10-22-2011, 07:27 PM
BOSCH ESItronic Tutorial install
1. Mount your ESI tronic image
2. Run Setup and you will see this:
Sometimes it takes few seconds sometimes minutes till it become 100%, it depends on the computer or OS.
3. After it will become 100% you will see this
So choose your language and continue
4. Then you will see this:
I always use the user defined installation, I never put any I-key (As I remember if you put FFFF – you will install all the bases – I don’t need them all – so it depends on you). Even if you don’t put any I-key you will
be also able to install full package – see next steps)
5. Then you will see this:
Change the installation directory if you wish then continue
6. Then this:
I always “tick” the: KTS 505-670 program CAS (you need to install the main program) and Data download
(It will make possible to install needed bases ) If you need other options like screen saver or Fuel injection
pump section – tick them.
7. Then this:
Now install the bases that you need using “drag and drop” method – to the drive that you wish. I use this
bases:
It depends on what you need or how much disk space you have. If you wonna learn more about the bases
read the attached: brochure_esi-tronic.pdf
8. Then this:
1. Mount your ESI tronic image
2. Run Setup and you will see this:
Sometimes it takes few seconds sometimes minutes till it become 100%, it depends on the computer or OS.
3. After it will become 100% you will see this
So choose your language and continue
4. Then you will see this:
I always use the user defined installation, I never put any I-key (As I remember if you put FFFF – you will install all the bases – I don’t need them all – so it depends on you). Even if you don’t put any I-key you will
be also able to install full package – see next steps)
5. Then you will see this:
Change the installation directory if you wish then continue
6. Then this:
I always “tick” the: KTS 505-670 program CAS (you need to install the main program) and Data download
(It will make possible to install needed bases ) If you need other options like screen saver or Fuel injection
pump section – tick them.
7. Then this:
Now install the bases that you need using “drag and drop” method – to the drive that you wish. I use this
bases:
It depends on what you need or how much disk space you have. If you wonna learn more about the bases
read the attached: brochure_esi-tronic.pdf
8. Then this:
Hit the buttons if this post help's you !!!
للراحه .... يمكنك التحدث معي بالعربيه
Forum Management
Hit the buttons if this post help's you !!!
للراحه .... يمكنك التحدث معي بالعربيه
Forum Management